Deep Well Pump, Stainless Steel 42 cbm/h
Item number: M-PU055
4162.50 je Stk. .
incl. VAT plus Shipping cost
For wells up to 122 meters, quantity max. 42000 L/h, power 11kW
Multistage submersible pump made of stainless steel. Stainless steel impellers.
Vertical and horizontal installation possible.
Built-in check valve.
Suitable for pumping clean, thin-bodied, non-aggressive media without solid or fibrous particles.
Stainless steel impellers
Pump head and internal check valve are made of stainless steel
Also available with Franklin engine
Pumping water from wells
Home and garden irrigation
For small agricultural and industrial plants
For fire extinguishing systems
For many other types of water supply
Rated power: 11 KW
Rotating speed: about 2830 rpm
Torque: about 10000 N
Insulation class: F
Protection: IP 58
Current consumption: approximately 23.0 A at 400 V three-phase, 3-phase, direct starter (DOL)
Voltage tolerance: + 10% / - 10%
Flow rate: 42000 l / h maximum
Delivery quantity: 122 m max.
Pressure: 12.2 bar maximum
Engine: 6 inches NEMA standard
Pump top: 6 inches NEMA standard
Stages (impellers): 15 Pieces
Discharge nozzle: 3 inch inner thread
Diameter: 95 mm
Overall height: aprx. 2037 mm
Motor housing: stainless steel V2A (AISI 304)
Motor shaft: Stainless steel V2A (AISI 304)
Pump head: Stainless steel V2A (AISI 304)
Check valve: built-in; A2 stainless steel (AISI 304)
Wheels: stainless steel V2A (AISI 304)
Diffussors: V2A stainless steel (AISI 304)
Bearings: Stainless Steel
Mechanical seal: Graphite / Ceramic
Sand deflector: Rubber
Sand content: 50 g / m³ at an approximately uniform distribution
Immersion depth: max. 200 m
Start Frequency: max. 20 starts per hour
Water temperature: Max. 30°C at 0.20 m / sec. flow rate
Cable: 20m, 30m, 40m, etc. available on request.
Quantity l/min. 100 200 250 300 350 400 450 500 550 600 650 700
m³/h 6 12 15 18 21 24 27 30 33 36 39 42
Deepth m 122 117 112 108 102 97 90 83 76 67 57 47